Thermopol Small

Acrylic polymerizing unit engineered in a stainless steel housing. Easy-to-read, precise and reliable control software. The working cycle is performed over two distinct stages: pre-heating and final polymerization, and all parameters of both stages can be adjusted according to requirements. The operating mode at the end of the cycle provides for the resistance to switch off automatically thus being assured of slow fall in temperature which will prevent any thermal shocks to the resin. Option to incorporate a pre-ignition timer. Side cock for quick water outlet.

IMPORTANT : This appliance is not suitable for operation on a standard North American 120V electrical circuit. Please read the SPECIFICATION section below before ordering this product.

CHARACTERISTICS

• Tanks capacity: 6 flasks (complete with clamps)
• Absorption : 1200 W
• Polymerizing temperature: 100 °C (boiling)
• Timer: up to 99 h 59 min
• Dimensions of the tank (mm) : 180x310x260H
• Outer dimensions (mm) : 200x440x420H
• Weight : 9 kg
• Voltage: AC 230 V at 50/60 Hz
  
  

IMPORTANT : This appliance is not suitable for use on a standard North American 120V electrical circuit. It will operate on a 240V@20Amp (NEMA 6-20R) electrical outlet using an appropriate Schuko CEE7/3 Female to NEMA 6-20R Male conversion. Contact a certified electrician if necessary. We are not responsible for the incompatibility of the appliance.

Alternatively a 3000W step-up transformer can be used instead.

Technical Data Sheet

Instruction Manual